Rectangular Hollow Pipe Weight Calculator Formula

Rectangular Hollow Pipe Weight Formula:

\[ Weight = 2 \times (L + W) \times T \times Length \times Density - 4 \times T^2 \times Length \times Density \]

Length (L):

Width (W):

Thickness (T):

Pipe Length:

Density:

kg/m³

Weight:

Unit Converter ▲

Unit Converter ▼

From:	To:

1. What is the Rectangular Hollow Pipe Weight Formula?

The Rectangular Hollow Pipe Weight Formula calculates the weight of a rectangular hollow section (RHS) pipe based on its dimensions and material density. This is essential for engineering, construction, and logistics planning.

2. How Does the Calculator Work?

The calculator uses the formula:

\[ Weight = 2 \times (L + W) \times T \times Length \times Density - 4 \times T^2 \times Length \times Density \]

Where:

\( L \) — Length of the outer rectangle (m)
\( W \) — Width of the outer rectangle (m)
\( T \) — Thickness of the pipe wall (m)
\( Length \) — Length of the pipe (m)
\( Density \) — Material density (kg/m³)

Explanation: The formula accounts for the outer dimensions while subtracting the hollow interior to get the actual material volume, then multiplies by density for weight.

3. Importance of Weight Calculation

Details: Accurate weight calculation is crucial for structural design, transportation planning, load capacity assessment, and cost estimation in construction projects.

4. Using the Calculator

Tips: Enter all dimensions in meters. Default density is set to 7850 kg/m³ (steel). For other materials, adjust density accordingly (e.g., aluminum = 2700 kg/m³).

5. Frequently Asked Questions (FAQ)

Q1: Why subtract 4×T² in the formula?
A: This accounts for the overlapping corners that would otherwise be double-counted in the simple perimeter calculation.

Q2: What's the difference between RHS and SHS?
A: RHS is rectangular hollow section, SHS is square hollow section (special case where L = W).

Q3: How accurate is this calculation?
A: Very accurate for standard manufactured pipes. For custom or non-standard pipes, actual measurements may vary slightly.

Q4: Can I use this for other shapes?
A: No, this formula is specific to rectangular hollow sections. Circular pipes and other shapes have different formulas.

Q5: What about material variations?
A: The density value can be adjusted for different materials (steel, aluminum, etc.) to get accurate weight calculations.